crwdns2915892:0crwdne2915892:0
Prerequisite only! This procedure is part of another guide and is not meant to be used alone.
Use this guide to disconnect the power cable wires from the switch on a Wacker M1500-120 REV 100 (2016) Concrete Vibrator.
crwdns2942213:0crwdne2942213:0
-
-
Pull up on the quick-disconnect handle to release the lock on the flex shaft.
-
Remove the flex shaft.
-
-
-
Use a T20 Torx screwdriver to remove the nineteen screws securing the two halves of the device housing.
-
-
-
-
Lay the device down onto its right side, screw holes facing up.
-
Remove the rear dust filter.
-
-
-
Lift to remove the left half of the device housing.
-
-
-
Lift the switch out of its recess in the case housing.
-
-
-
Use a pair of needle nose pliers to disconnect the black and white power wires from their terminals on the switch.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
