crwdns2942213:0crwdne2942213:0
-
-
First, locate the three screws on the top of the sander.
-
Using a screw driver with a size T20 star bit, unscrew the screws by turning them to the left.
-
-
-
-
Locate your on off switch and in order to remove it you must slide it out of its slot.
-
This shouldnt require any special tools, just wiggle the switch up and out.
-
Make sure this is done carefully, the switch is attached to two wires that may break if they are pulled on too hard.
-
-
-
Using a spudger such as the one shown, carefully pry open the connectors as shown just enough to slide the prongs of the switch out.
-
Once both prongs are open, the on-off switch can be removed freely and replaced with a new switch.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 8-7, Botvin Spring 2016 crwdns2935289:0UMass Dartmouth, Team 8-7, Botvin Spring 2016crwdne2935289:0
UMASSD-BOTVIN-S16S8G7
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
