crwdns2915892:0crwdne2915892:0
Use this guide to replace the speakers on your Polaroid A10.
crwdns2942213:0crwdne2942213:0
-
-
Begin by having the side with volume and power button face up towards you.
-
Insert a plastic opening tool between the display and the back cover.
-
Once you have one plastic opening tool in, you can insert another one. While holding one in place, slide the other along the gap to release the tabs.
-
-
-
The speakers are located on the bottom of the device, below the battery and adjacent to the motherboard.
-
-
-
-
Using the Phillips #000 screwdriver, remove the two 7 mm screws located in the picture by rotating the screw counter-clockwise.
-
Carefully remove the speakers from original position without pulling out the wires.
-
-
-
Using the soldering tool, remove the two small black wires and two small red wires from the motherboard.
-
The wire connections are located on the motherboard next to the corner of the battery closest to the motherboard.
-
-
-
Gently lift the speakers up and out of the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UW Tacoma, Team 3-3, Rose Winter 2015 crwdns2935289:0UW Tacoma, Team 3-3, Rose Winter 2015crwdne2935289:0
UWT-ROSE-W15S3G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2944067:03crwdne2944067:0
This is not what I meant I wanted to know what to do if the wires came out of the
If the wires and out of the
Speaker right
