crwdns2915892:0crwdne2915892:0
This guide shows you how to disassemble and replace the microphone on your Playstation VR headset.
crwdns2942213:0crwdne2942213:0
-
-
Peel back the rubber covering around the lenses to remove the surrounding plastic eyepieces.
-
-
-
Unscrew four 13 mm screws with a PH #000 screwdriver.
-
-
-
Using the plastic opening tool, carefully pry the white plastic panel free from the side of the headset. Repeat this action for the opposite side.
-
-
-
Use the plastic opening tool to pry the top white plastic panel free from the headset.
-
-
-
Flip the headset over.
-
Using a PH #000, unscrew the 7 mm screw found on the bottom of the headset.
-
-
-
-
Using the plastic opening tool, pry the bottom white plastic panel loose and remove it from the headset.
-
-
-
Unscrew the two 7 mm screws from the top of the headset.
-
-
-
Using your fingers, carefully pry the black front panel free from the headset.
-
-
-
Unscrew the four silver 6 mm screws in each corner using a PH #000 screwdriver.
-
-
-
Lift the small silver latch attaching the ZIF (zero insertion force) connector to the circuit board.
-
Carefully pull the end of the white ribbon connector from its slot.
-
-
-
Unhitch the yellow led connector ribbon and move it aside.
-
-
-
Carefully pry the black plastic piece attaching the yellow ribbon to the headset away from the green circuit board.
-
Remove the yellow LED ribbons and black plastic connecting piece from the headset.
-
-
-
Pinch the small white cable connector and unplug it from the motherboard.
-
The microphone will be attached to the white cable connector on the bottom right of the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0