crwdns2915892:0crwdne2915892:0
Video tutorial - how to replace Laser Lens only:
crwdns2942213:0crwdne2942213:0
crwdns2936621:0crwdne2936621:0
-
-
Use the flat end of a spudger or your fingernail to flip up the retaining flap on the Blu-ray ribbon cable socket.
-
-
-
-
Pull the Blu-ray ribbon cable straight up and out of its socket.
-
-
-
Pull the Blu-ray power cable straight up to lift its connector out of the socket on the Blu-ray drive.
-
-
-
Remove the single 9.5 mm Phillips screw securing the Blu-ray drive to the lower case.
-
-
-
Lift the Blu-ray drive slightly by its right edge to dislodge the control board from its housing.
-
Remove the Blu-ray drive from the PS3.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:020crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Master Techs crwdns2935289:0Master Techscrwdne2935289:0
Community
crwdns2931471:0326crwdne2931471:0
crwdns2935297:01,688crwdne2935297:0
crwdns2947412:05crwdne2947412:0
Donde puedo comprar refacciones y partes para PS3 Slim?
yo vendo amigo = ivaramso@gmail.com para ventas
How can this be easy, but the Blu-Ray drive be considered Moderate? You need to complete the Blu-Ray drive removal prior to replacing the laser lens, which means this is at best a Moderate task.
This is not lens replacement, this is drive replacement. Is there a separate guide for lens replacement?
Shows how to do the laser assembly in the video but not how to reinstall it in the drive. Lazy guide. Just buy a whole new drive if you are following this guide.
