crwdns2915892:0crwdne2915892:0
The following steps are a brief guide on how to replace the handle of the Philips Norelco beard trimmer 3100.
crwdns2942213:0crwdne2942213:0
-
-
Remove the comb from the top of the trimmer.
-
-
-
Place your thumb underneath the blade and push upward to remove it.
-
-
-
Hold trimmer towards you as shown in the diagram.
-
Insert your prying tool/metal spudger into the marked area.
-
-
-
-
Apply gentle pressure and begin prying open the back panel.
-
Separate the panel one notch at a time. Listen carefully as you're prying the panel apart and notice each individual notch release.
-
-
-
Pull the trimmer apart using your hands once the panel is at least halfway apart.
-
Pull the wires attached to the battery off of the power connectors before completely removing the back panel.
-
-
-
Hold the trimmer towards you.
-
Place the metal spudger tool in the marked area.
-
-
-
Apply gentle pressure and begin prying the front panel.
-
Separate the front panel one notch at a time.
-
-
-
Pull the trimmer apart using your hands once the panel is at least halfway apart.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0