crwdns2915892:0crwdne2915892:0
Replacement guide for the circuit board of the Pebble Time.
crwdns2942213:0crwdne2942213:0
-
-
Lay the watch flat on your workstation.
-
-
-
Use the metal spudger to carefully pull apart the screen cover from the case.
-
Replace the metal spudger with a plastic opening tool to hold the cover open.
-
-
-
Use the metal spudger tool to carefully loosen the rest of the cover.
-
-
-
Carefully, pull apart the cover with the plastic opening tool.
-
-
-
-
Insert metal spudger into the side of the screen shown in the picture.
-
-
-
Use the metal spudger to pry the screen up.
-
-
-
Once screen is lifted, insert plastic opening tool between the screen connector and circuit board.
-
Disconnect the screen from the circuit board.
-
-
-
Keep the watch flat on your workstation.
-
-
-
Locate the three screws on the circuit board.
-
Remove using the J000 Philips head screwdriver.
-
-
-
Carefully disconnect the connector wire on the bottom left edge of the circuit board using a plastic opener tool.
-
Move apart the connector to expose the fourth screw.
-
-
-
Remove the final screw from the circuit board with a J000 Philips head screwdriver.
-
-
-
Turn the watch to the side and use the plastic opening tool to lift up the circuit board.
-
Remove the circuit board from the case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-3, Sullivan Spring 2017 crwdns2935289:0USF Tampa, Team 1-3, Sullivan Spring 2017crwdne2935289:0
USFT-SULLIVAN-S17S1G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:07crwdne2935297:0
