crwdns2915892:0crwdne2915892:0
This guide shows how to remove the LCD screen from the circuit board and replace it.
crwdns2942213:0crwdne2942213:0
-
-
Locate the memory card and battery card latch on the bottom of the camera.
-
Slide the latch to the open position.
-
-
-
Open the battery latch, and slide the battery release lever to the right.
-
-
-
Remove the three 4.6 mm screws on the bottom of the camera using a Phillips #00 screwdriver.
-
-
-
-
Remove the single 3.2 mm screw on the left side of the camera using a Phillips #00 screwdriver.
-
-
-
Remove the two 3.2 mm screws on the right side of the camera using a Phillips #00 screwdriver.
-
-
-
Gently remove the back casing.
-
Start at the bottom and carefully pry towards the top to get this piece free.
-
-
-
Gently lift up the LCD screen.
-
Using a plastic prying tool, flip up the latch that holds the thin ribbon in place.
-
It should fall out on its own or with a gentle tug.
-
-
-
Gently tug the thicker ribbon to remove it from its housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0