crwdns2915892:0crwdne2915892:0
Are you noticing any dust, smudges, or debris that’s preventing you from taking clear videos on your Panasonic HDC-TM90? This guide walks you through the careful process of disassembling your camcorder to access your lens and clean it from the inside.
A clean lens is needed to optimize image quality to ensure you produce clear, sharp videos and remove any unwanted visual effects.
Be sure to power off the camcorder before beginning to repair the device.
crwdns2942213:0crwdne2942213:0
-
-
Slide the battery release switch away from the battery.
-
-
-
While holding the switch away from the battery, push the battery out of the slot.
-
-
-
Remove 5 screws from the side panel body of the camcorder.
-
Use the spudger to remove the top of the camcorder.
-
-
-
Unscrew three screws to remove the lens rim on the front of the camcorder.
-
-
-
Remove the rubber ring around the lens.
-
-
-
Unscrew the lens by removing the three screws connected to it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Baylor, Team 8-4, Whitney Spring 2017 crwdns2935289:0Baylor, Team 8-4, Whitney Spring 2017crwdne2935289:0
BU-WHITNEY-S17S8G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Steps 1-4: good pre-req
Step 5-bullet 1: Which screwdriver and how many screws? There seem to be a lot of screws so perhaps numbering how many and where they came from would be helpful. Maybe color coding your steps with more details using markers of how many screws and what location in the pictures would be helpful.
Step 5 bullet 1 and 2 should probably be 2 separate steps.
Step 5- bullet 2: could use a picture
Step 6: Did not seem to be how we did this step at all. Perhaps this could be explained in much more detail with more detailed pictures. Also the cautions and warnings should be labeled as such.
