crwdns2915892:0crwdne2915892:0
Is your shaver not working even when its batteries have been replaced? if so, here is the guide to fix the problem by replacing the motor. All you need is a standard Phillips Screwdriver to remove two screws during the replacement.
crwdns2942213:0crwdne2942213:0
-
-
Twist the release cap to expose the batteries.
-
-
-
Remove the razor guard by pushing its release buttons and pulling.
-
-
-
-
Remove the two 1.9mm Phillips #0 screws from the inner blades.
-
-
-
Pull the outer casing with one hand while holding the inner battery casing with the other hand.
-
-
-
Detach the white plastic blade base from the tip of the motor by pulling it.
-
-
-
Detach motor from gray plastic holder by pulling it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.