crwdns2915892:0crwdne2915892:0
This guide will walk you through the steps to remove and replace the front panel on a Palm T|X.
crwdns2942213:0crwdne2942213:0
-
-
Orient the device so that the display faces forward.
-
Remove the stylus from the right side.
-
-
-
Turn over the device so that the back panel faces forward.
-
Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.
-
-
-
Rotate the device so that the display faces forward.
-
Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.
-
Pry along the crevice to loosen the back panel.
-
Repeat this process for the right side.
-
-
-
Carefully pry the back panel to open the device.
-
-
-
-
Use a plastic opening tool to peel the battery pack from the back panel.
-
-
-
Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them.
-
-
-
Lift the mother board out of the device.
-
-
-
Orient the device sideways, as shown in the picture.
-
Lightly push the front of the display to separate it from the front panel.
-
-
-
Use a T5 Torx screwdriver to remove the 7.75mm screws at the bottom of the device.
-
-
-
Lift the button and connector assembly from the front panel.
-
-
-
Lift the rubber buttons off the front panel.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0