crwdns2915892:0crwdne2915892:0
The following guide will show the reader how to properly remove the motherboard from the Palm Pre 2.
crwdns2942213:0crwdne2942213:0
-
-
Snap off the back panel to reveal the battery using the opening tool.
-
-
-
Pull on the tab to remove the battery.
-
-
-
Use the T5 Torx Screwdriver to remove the six screws that hold the back of the frame in place.
-
-
-
-
Use a spudger to open the hinge that covers the black and white GPS and DIV antennas (Reference the red box in the image).
-
Use tweezers to remove the two antennas from the keypad control board.
-
-
-
Use the opening tool to pry off the (black and yellow) back frame.
-
-
-
Use the opening tool to remove the panel on the main part of the phone.
-
Use the tweezers to get access to remove the panel giving access to the cable connectors.
-
Remove the two ribbon cable connectors using the tweezers.
-
-
-
Use tweezers to separate the keyboard from the phone.
-
-
-
Use a Phillips #0 screwdriver to remove the remaining 4 screws from the main portion of the phone.
-
Use an opening tool to remove the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S1-G6, Freund Spring 2018 crwdns2935289:0IUPUI, Team S1-G6, Freund Spring 2018crwdne2935289:0
IUPUI-FREUND-S18S1G6
crwdns2931471:02crwdne2931471:0
crwdns2935297:04crwdne2935297:0
