crwdns2915892:0crwdne2915892:0
Installing a new motherboard assembly which contains the processor and software package.
crwdns2942213:0crwdne2942213:0
-
-
Place the Palm IIIx face down on a flat surface.
-
-
-
Push down and lift up the battery cover to remove it.
-
-
-
Remove the old batteries one at a time.
-
-
-
Using a Phillips #00 screwdriver, remove the four screws that hold the back cover in place.
-
-
-
-
Hold the device on its side, positioning your hands as shown.
-
Remove the back cover by pushing in with your thumbs and pulling outward with the rest of your fingers.
-
-
-
Hold the screen and front cover on its side, facing the screen inward as shown.
-
Remove the screen by pushing outward with your thumbs. Use your index fingers to hold the front cover in place.
-
-
-
Position the device with the screen facing down.
-
Locate the white ribbon wire on the left hand side of the device.
-
On either side of the ribbon wire are two white clasps. Gently push the two clasps away from the board (to the left).
-
-
-
Detach the ribbon wire by gently pulling it out of its connector.
-
-
-
Separate the motherboard from the screen.
-
-
-
Now the motherboard assembly can be replaced successfully.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 14-43, Regan Winter 2010 crwdns2935289:0Cal Poly, Team 14-43, Regan Winter 2010crwdne2935289:0
CPSU-REGAN-W10S14G43
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
