crwdns2915892:0crwdne2915892:0
Triggers may need to be replaced if they become worn out or too sensitive. If you need to replace the triggers on your PDP Rematch Advanced controller, follow this guide. The triggers can be taken out by unscrewing them from the motherboard.
crwdns2942213:0crwdne2942213:0
-
-
Orient the controller so the back side is facing you.
-
Use a Phillips #000 screwdriver to remove the seven 9 mm screws that secure the back shell.
-
-
-
Pull apart the controller's front and back shells with moderate force.
-
-
-
-
Use a Phillips #00 screwdriver to remove the two 5 mm screws that secure the motherboard.
-
-
-
Remove the motherboard from the back shell using moderate force.
-
-
-
Use a Phillips #00 screwdriver to remove the two trigger springs from the motherboard.
-
-
-
Use a hair dryer to remove the trigger from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.