crwdns2915892:0crwdne2915892:0
If the deadbolt in your gate is worn, malfunctioning, or damaged, you can easily replace it with a new one by following this guide. To do so, you will need a cross-head screwdriver and the new deadbolt.
There are a few common sizes for deadbolts. By using a tape measure to find the diameter of the pre-existing hole and the thickness of the gate, you can determine the correct choice for your gate.
crwdns2942213:0crwdne2942213:0
-
-
From the front side of the gate, push the latch into the center of the opening. Adjust as needed.
-
Screw both of the short screws into the panel to the right of the latch.
-
-
-
Grab both of the long screws.
-
Adjust the back head of the doorknob to be facing in a straight upward position.
-
Screw in the long screws.
-
-
-
The back end and the front face of the deadbolt must line up.
-
Screw in the screws until they are fully tightened.
-
-
-
Test out the new deadbolt with a key or door handle, depending on which one you may have.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
CSU Los Angeles, Team 1-26, Harris Spring 2024 crwdns2935289:0CSU Los Angeles, Team 1-26, Harris Spring 2024crwdne2935289:0
CSULA-HARRIS-S24S1G26
crwdns2934841:01crwdne2934841:0
crwdns2935303:01crwdne2935303:0
