crwdns2937539:0crwdnd2937539:0crwdne2937539:0
crwdns2915892:0crwdne2915892:0
The gear shaft is responsible for spinning the blades.
crwdns2942213:0crwdne2942213:0
-
-
Use the prying tools to open the four plastic screw holes on the bottom of the blender.
-
-
-
Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.
-
-
-
-
Use the spudger to detach the black wire from the circuit board.
-
Repeat for yellow wire.
-
-
-
Use the Phillips #1 to remove the four 8mm screws.
-
Use the medal spudger to detach the circuit board from the buttons.
-
Gently pull and release circuit board from buttons.
-
-
-
Remove the screw on top of the fan with the 4mm socket stock wrench.
-
Remove the fan and washer.
-
-
-
Remove the four screws with the 4mm socket stock wrench.
-
Remove gear shaft.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0