crwdns2894164:0crwdne2894164:0

crwdns2892376:0crwdne2892376:0

The circuit board is the main control center of the blender.

crwdns2860947:0crwdne2860947:0

crwdns2890040:0crwdne2890040:0

  1. Use the prying tools to open the four plastic screw holes on the bottom of the blender.
    • Use the prying tools to open the four plastic screw holes on the bottom of the blender.

  2. Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.
    • Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.

  3. Gently remove the circuit board.
    • Gently remove the circuit board.

  4. Use the spudger to detach the black wire from the circuit board. Repeat for yellow wire.
    • Use the spudger to detach the black wire from the circuit board.

    • Repeat for yellow wire.

  5. Use the Phillips #1 to remove the four 8mm screws. Use the medal spudger to detach the circuit board from the buttons. Gently pull and release circuit board from buttons.
    • Use the Phillips #1 to remove the four 8mm screws.

    • Use the medal spudger to detach the circuit board from the buttons.

    • Gently pull and release circuit board from buttons.

crwdns2892372:0crwdne2892372:0

To reassemble your device, follow these instructions in reverse order.

crwdns2878480:0crwdne2878480:0

Tristian Cruz

crwdns2886885:020/09/2017crwdne2886885:0

263 crwdns2894548:0crwdne2894548:0

crwdns2886889:02crwdne2886889:0

crwdns2892814:0crwdne2892814:0

University of North Texas, Team S7-G8, Thomas Fall 2017 crwdns2886886:0University of North Texas, Team S7-G8, Thomas Fall 2017crwdne2886886:0

UNT-THOMAS-F17S7G8

crwdns2858115:03crwdne2858115:0

crwdns2886889:04crwdne2886889:0

crwdns2892924:00crwdne2892924:0

crwdns2892926:0crwdne2892926:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 0

crwdns2894768:030crwdne2894768:0 3

crwdns2894770:0crwdne2894770:0 215