crwdns2915892:0crwdne2915892:0
The power cord is responsible for providing power to your device. This guide will instruct you on how to replace the power cord.
crwdns2942213:0crwdne2942213:0
-
-
Use the prying tools to open the four plastic screw holes on the bottom of the blender.
-
-
-
Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.
-
-
-
-
Use the spudger to detach the black wire from the circuit board.
-
Repeat for yellow wire.
-
-
-
Use the Phillips #1 to remove the four 8mm screws.
-
Use the medal spudger to detach the circuit board from the buttons.
-
Gently pull and release circuit board from buttons.
-
-
-
Locate petal prong on the end of the power cord.
-
Bend metal prong until it's straight with your finger.
-
-
-
Pinch plastic prongs on base of blender to remove plastic securing device.
-
Remove plastic securing device.
-
Pull power cord out of blender base.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.