crwdns2915892:0crwdne2915892:0
Removing the power cord is straightforward, but it does require soldering.
crwdns2942213:0crwdne2942213:0
-
-
Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.
-
-
-
Push the plastic push-down handle down and pull the plastic handle straight from metal arm.
-
-
-
Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.
-
-
-
-
Using a flat-head screwdriver, pry the power cord from the base of the toaster.
-
-
-
Using a flat-head screwdriver, pry the white wire from the base.
-
-
-
Locate the circuit board at the front of the toaster where the power cord and white wire meet.
-
Pull the circuit board up and out to free the circuit board from the body of the toaster.
-
-
-
Desolder the power cord from the circuit board at the locations show in the diagram.
-
-
-
Unscrew the two 1.5cm Phillips-head screws at the back of the toaster that are holding the power cord in place to remove the retaining clip.
-
Remove the plastic retaining clip that is holding the cord in place.
-
-
-
Pull the cord from the base to remove the cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 13-15, Regan Winter 2014 crwdns2935289:0Cal Poly, Team 13-15, Regan Winter 2014crwdne2935289:0
CPSU-REGAN-W14S13G15
crwdns2931471:05crwdne2931471:0
crwdns2935297:06crwdne2935297:0
