crwdns2942213:0crwdne2942213:0
-
-
Remove the Blender Container from the Blender Base.
-
-
-
Flip the blender so the bottom is facing you.
-
-
-
Unscrew the 16mm screws located on the plastic bottom from the blender base using a Phillips #2 screwdriver.
-
-
-
Remove the plastic bottom from the base of the blender.
-
-
-
-
Holding the center of the fan, grip the knob in the center of the top of the blender with a wrench and twist the wrench counterclockwise.
-
-
-
Carefully remove the motor and fan from the base of the blender.
-
-
-
Now, gently pull the white wire that is connected to the base and the motor.
-
-
-
Now, turn the motor over, and remove the black wire from the motor.
-
-
-
Now de-solder the yellow wire from circuit board. De-solder the wire following these instructions.
-
-
-
Locate the four 11mm screws in the circuit board.
-
Unscrew the four screws using the Phillips #1 screwdriver.
-
-
-
Desolder the circuit board from the base at the indicated point, following the directions by clicking here.
-
Now separate the circuit board from the base.
-
-
-
You will see that the circuit board is still attached by a red wire and a black wire.
-
Flip the circuit board back over and desolder at the indicated points following the directions given here.
-
Now your circuit board is ready to be replaced. To reassemble your device, follow these instructions in reverse order.
Now your circuit board is ready to be replaced. To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 12-37, Maness Spring 2014 crwdns2935289:0Cal Poly, Team 12-37, Maness Spring 2014crwdne2935289:0
CPSU-MANESS-S14S12G37
crwdns2931471:04crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947412:010crwdne2947412:0
So, a question. Where does the spring go? I was fixing one of these and the spring fell out and I never saw where it came from.
inside 2 tubes that stick out opposite of each other just below the fan.
Spring goes on the one of the strips that slides back and forth....it has small end which goes in a small notched cavity of the plastic housing. Spring goes on that longer end of the stripe. See the picture in step 12...its popped out from the plastic housing.
conoces el orden de las laminas del circuito de velocidades…? agradecere cualquier sugerencia…
Awesome, this guide was really helpful in repairing my blender. Thumbs up for the author.
