crwdns2915892:0crwdne2915892:0
If the buttons in the back case of your camcorder are broken, you can replace them by following these steps.
crwdns2942213:0crwdne2942213:0
-
-
Pull the slider labeled open, on the bottom right, to unlock the battery.
-
-
-
Unfold the screen from the side of the camera.
-
-
-
Twist the screen so that the screen is facing downward.
-
-
-
-
Unscrew the four screws on the side (length 2.9 mm) with a JIS #000 screwdriver.
-
Unscrew the three screws on the bottom (length 7.7 mm) with a JIS #000 screwdriver.
-
-
-
Pull apart the camera into two pieces by pulling the side with the screen away from the main body of the camera.
-
-
-
Unscrew the two screws (size 4.75 mm) with a PH #00 screwdriver.
-
Unscrew the screw (size 7.65 mm) with a PH #00 screwdriver.
-
-
-
Take the back case off by pulling it away from the main body.
-
-
-
Unscrew all four screws (length 4.13 mm) on the inside of the case with a PH #00 screwdriver.
-
-
-
Pull the board away from the back case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.