crwdns2915892:0crwdne2915892:0
Use this guide to remove the focal lens from your Optoma HD20.
crwdns2942213:0crwdne2942213:0
- 
   
   - 
                     
            Twist the focal cap clockwise until it is fully extended. 
- 
                     
            Remove the focal cap by pulling it straight out. 
 
- 
                     
            
- 
   
   - 
                     
            Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device. 
 
- 
                     
            
- 
                     
                                                
- 
   
   - 
                     
            Use a plastic opening tool to gently pry the top cover off of the device. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the ribbon by disconnecting it from the main circuit board. 
- 
                     
            Lift up the clip holding it down and pull the ribbon out. 
 
- 
                     
            
- 
   
   - 
                     
            Use a Phillips #1 screwdriver to unscrew the small black 2 mm screw on the side of the focal lens. 
 
- 
                     
            
- 
   
   - 
                     
            Remove the focal lens by twisting it clockwise until it comes off. 
 
- 
                     
            
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
