crwdns2915892:0crwdne2915892:0
This guide shows how to replace the motherboard on the Oontz Angle 3 Ultra in the case of water damage or other types of damage. The device would likely not work or have a strange behavior. Follow this guide to replace the motherboard and get the Oontz Angle 3 Ultra working again.
crwdns2942213:0crwdne2942213:0
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the two black rubber sheaths around the edges of the speaker.
-
Under the symbol-marked sheath there is a white rubber covering for the buttons. Peel this away to reveal the panel underneath.
-
On two corners of its triangular face there is a small divot, which allows you to use your fingernails or a pair of tweezers to grip and peel away the covering.
-
-
-
Use a JIS #0 screwdriver to remove the six screws to expose the motherboard.
-
-
-
Using a pair of tweezers, pinch and pull the rubber fillings obstructing the screws.
-
-
-
-
Using a JIS #0 screwdriver, remove the 6 screws holding the backplate in.
-
Remove the back panel off of the device.
-
-
-
Using the spudger, remove the motherboard from the device.
-
-
-
Using a soldering iron, remove microphone wires attached to the motherboard.
-
Melt the solder on the battery terminals on the motherboard and pull the wires through the backside of the board.
-
For more information on soldering, please visit the How to Solder and Desolder Connections guide.
-
-
-
Using a spudger, disconnect the speaker bus female connector from the motherboard's male bus.
-
Remove the grounding wire from the back of the motherboard by gently pulling the metal connection directly away from the board.
-
-
-
With the new motherboard, re-solder all of the wiring into their appropriate soldering locations and wiring harnesses.
-
Reassemble the speaker in reverse order.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team S6-G9, Rauch Spring 2020 crwdns2935289:0Embry-Riddle Aeronautical University, Team S6-G9, Rauch Spring 2020crwdne2935289:0
ERAU-RAUCH-S20S6G9
crwdns2931471:03crwdne2931471:0
crwdns2935297:06crwdne2935297:0
crwdns2947412:03crwdne2947412:0
Greetings.
Where can I find boards for my Angle 3 Ultra ??
Same problem
can we have the parts of mother board so we as a beginner in electricians need this
