crwdns2915892:0crwdne2915892:0
This guide will help you open up your Oontz Angle 3 Ultra, which will allow you to work on its sensitive internals. To open up the speaker, you must remove the back panel to access the inner components of the device.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two black rubber sheaths around the edges of the speaker.
-
Under the symbol-marked sheath there is a white rubber covering for the buttons. Peel this away to reveal the panel underneath.
-
On two corners of its triangular face there is a small divot, which allows you to use your fingernails or a pair of tweezers to grip and peel away the covering.
-
-
-
Use a JIS #0 screwdriver to remove the six screws to expose the motherboard.
-
-
-
-
Using a pair of tweezers, pinch and pull the rubber fillings obstructing the screws.
-
-
-
Using a JIS #0 screwdriver, remove the 6 screws holding the backplate in.
-
Remove the back panel off of the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0