crwdns2915892:0crwdne2915892:0
This guide will detail how to replace the touchpad in the One Education Infinity:One laptop.
crwdns2942213:0crwdne2942213:0
-
-
Use a spudger to pry the four rubber pads away from the bottom of the case.
-
Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.
-
-
-
Insert a Jimmy or other prying tool into the seam on the edge of the casing.
-
Trace along the edges of the device until all clips are released.
-
Lift the back case away from the device.
-
-
-
Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.
-
-
-
Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.
-
-
-
-
Flip up the black retaining flap on the ZIF connector holding the large grey ribbon cable in place.
-
Pull the ribbon cable straight out of the ZIF connector.
-
-
-
Use the flat end of a spudger to flip up the black tab on the smaller ZIF connector.
-
Use tweezers to pull the ribbon cable straight out of the connector.
-
-
-
Use a Phillips #000 screwdriver to unscrew the three 3.4mm screws.
-
Lift the daughterboard away from the device to remove.
-
-
-
Use a spudger to lift up the black retaining flap on the touchpad's ZIF connector.
-
Pull the ribbon cable straight back to remove.
-
-
-
Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws holding the touchpad in place.
-
-
-
Feed the ribbon cable through the hole in the metal frame.
-
Left the metal frame away from the device.
-
-
-
Use a spudger to pry the touchpad away from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
