crwdns2915892:0crwdne2915892:0
This guide will teach you how to remove the speakers for the Onda VI10.
crwdns2942213:0crwdne2942213:0
-
-
Use a number 0 screw driver to remove the four screws.
-
-
-
Power Button on the side should be pointing outward.
-
Note: This is so the ribbon cables inside are not damaged.
-
-
-
-
Locate the black and red speaker wires going back to the mother board.
-
-
-
Carefully remove the speaker cables from the retaining tabs using a thin metal spudger.
-
-
-
Pry the speaker out of its molding using a thin metal spudger
-
-
-
Desolder the two speaker wires from the motherboard using a soldering iron.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.