crwdns2915892:0crwdne2915892:0
The drive socket in your Nutribullet Rx #NB-301 can become loose over time due to frequent usage. When this happens, the drive gear becomes wobbly, causing it to get stuck and stop turning. Fortunately, the drive socket can be replaced. If you are experiencing this issue with your Nutribullet Nutrient Extractor #NB-301, follow this guide to replace the drive socket and start using your blender again!
crwdns2942213:0crwdne2942213:0
-
-
Flip the blender over so the bottom is facing up.
-
Use a Phillips #2 screwdriver to remove the four 10 mm screws from the base of the blender.
-
Remove the base cover from the blender.
-
-
-
Clamp down on the nut above the socket with the needle nose pliers so it stays in place for the next step.
-
-
-
Lay the blender on its side and hold the drive socket with the needle nose pliers to keep in from turning so you can remove the screw.
-
Use a Phillips #2 screwdriver to remove the screw securing the drive socket.
-
-
-
-
Remove the drive socket from the motor.
-
-
-
Remove all dust and residue from the area before you replace your new drive socket.
-
-
-
Use a Phillips #2 screwdriver to secure the drive socket to the motor.
-
-
-
Place the bottom cover back on the blender.
-
Use the Phillips #2 screwdriver to replace the four 10 mm screws on the back cover back.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
CSU Los Angeles, Team 7-3, Grodsky Spring 2024 crwdns2935289:0CSU Los Angeles, Team 7-3, Grodsky Spring 2024crwdne2935289:0
CSULA-GRODSKY-S24S7G3
crwdns2931471:02crwdne2931471:0
crwdns2935303:01crwdne2935303:0
