crwdns2942213:0crwdne2942213:0
-
-
Orient the phone as shown.
-
Press the button with the plastic opening tool and slide the back case downward relative to the phone.
-
-
-
Remove the battery cover by lifting it away from the phone.
-
-
-
Insert the plastic opening tool into the marked space.
-
Lift up the side of the battery closest to the bottom edge of the phone using the plastic opening tool.
-
-
-
-
Insert the plastic opening tool in the marked areas in between the front and back covers.
-
Pry each corner with the plastic opening tool until the front case completely detaches.
-
-
-
Remove the keypad by lifting it away from the phone.
-
-
-
Use the T6 Torx screwdriver to remove the six 15 mm Torx screws.
-
-
-
Lift the bottom edge of the front panel at a 45 degree angle.
-
Remove front panel by slowly pulling it away from the phone at a 45 degree angle.
-
-
-
Locate the speaker location located on the back panel of the phone.
-
Using the tweezers place one side of tweezers in the rectangular slot where the speaker is located
-
Slowly lift speaker away from the back panel.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 6-2, Regan Fall 2011 crwdns2935289:0Cal Poly, Team 6-2, Regan Fall 2011crwdne2935289:0
CPSU-REGAN-F11S6G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:010crwdne2935297:0
