crwdns2915892:0crwdne2915892:0
You need a T5 screwdriver to remove the screws.
crwdns2942213:0crwdne2942213:0
-
-
In order to remove the back cover, you must press the indicated button.
-
-
-
With the button pressed, apply light pressure and slide the back cover off.
-
This will allow you to access the battery
-
-
-
In order to remove the battery, pull it out from the same side that the rubber button is on.
-
-
-
Using a plastic opening tool, separate the back cover from the phone.
-
-
-
Continue along the edge with the plastic opening tool.
-
-
-
-
Unscrew the indicated screws using the T5 screwdriver.
-
-
-
Open the phone up and use the plastic opening tool to remove the cover to the keyboard.
-
Be careful not to break the plastic during this step; do your best not to force anything.
-
-
-
The button board will be loose once the cover is removed.
-
Lift it up to reveal the sensor board.
-
-
-
With the T5 Screwdriver, remove the marked screws.
-
-
-
With the screws removed, the sensor board should be free to flip up.
-
-
-
Disconnect the wire with the plastic opening tool.
-
-
-
Remove the screws marked.
-
The Screw on the left is located underneath the cable.
-
With those screws removed, the circuit board and sensor board will be detached from the rest of the phone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 18-21, Garner Spring 2011 crwdns2935289:0Cal Poly, Team 18-21, Garner Spring 2011crwdne2935289:0
CPSU-GARNER-S11S18G21
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
