crwdns2915892:0crwdne2915892:0
Sometimes when remotes stop working, the problem could be from old batteries left in the remote that leaked battery acid and caused corrosion to appear. This guide will help you take apart and clean the corroded areas in a Nintendo Wii remote. As this deals with batteries that leaked, safety precautions should be in place, like gloves and proper disposal of the batteries.
It is important to note that while this guide helps clean corrosion, batteries are not the only cause of faulty remotes, since water damage can also cause corrosion on the motherboard.
crwdns2942213:0crwdne2942213:0
-
-
Remove the battery cover and the batteries.
-
Remove the four tri-point Y1 screws holding the remote together.
-
-
-
Using an opening tool, apply pressure to the tabs located near the "A" button.
-
Remove the faceplate.
-
-
-
To remove the motherboard, press up on the "B" button, and then the connector at the bottom.
-
-
-
-
Unclip the tabs to remove the plastic piece.
-
On the back, move the vibration motor out of the way to completely remove the plastic piece.
-
-
-
Find any corrosion on the motherboard.
-
Corrosion on the motherboard will have a blueish color and may appear in multiple places.
-
Check the battery terminals for corrosion.
-
-
-
Clean the corroded areas with isopropyl alcohol and a toothbrush.
-
-
-
Clean the terminals with isopropyl alcohol and a toothbrush or Q-tips.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:011crwdne2935229:0
crwdns2944067:02crwdne2944067:0
Would 99% Isopropyl Alcohol also be okay to use as cleaner?
Of course, I use this for cleaning every type of motherboard, the difference between 99% and 70% is that the solution contains less water, so the liquid evaporate in less time :)
ReDeath_ -