crwdns2915892:0crwdne2915892:0
This guide will show you the steps on installing the joystick. This will be helpful if the joystick isn't working properly.
crwdns2942213:0crwdne2942213:0
-
-
Pull down on the battery cover release lever and pull back to remove the cover.
-
-
-
Remove both batteries from the device.
-
-
-
-
Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.
-
-
-
Carefully turn over the controller and place it on a flat surface.
-
Slowly separate the top panel from the bottom panel.
-
Once separated, set aside the top panel.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to remove the buttons.
-
-
-
Grab the base of the grey joystick cover with one hand and firmly hold down the rest of the controller with the other hand.
-
Pull off the grey joystick cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:08crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 10-40, Amido Spring 2013 crwdns2935289:0Cal Poly, Team 10-40, Amido Spring 2013crwdne2935289:0
CPSU-AMIDO-S13S10G40
crwdns2931471:04crwdne2931471:0
crwdns2935297:037crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Question. My wavebird joystick wobbles a lot and gets stuck in directions I’m not inputting. Will replacing the top of the stick fix this? Or would I have to solder a new analog stick to the board?
