crwdns2915892:0crwdne2915892:0
The Z button is located above the right trigger but functions as a button.
crwdns2942213:0crwdne2942213:0
-
-
Place the controller (buttons down) on a solid surface.
-
Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.
-
-
-
-
Gently lift the back panel up, separating it from the front panel.
-
-
-
Grab the Z-button by the peg with tweezers and lift it out of the controller.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 19-44, Regan Winter 2013 crwdns2935289:0Cal Poly, Team 19-44, Regan Winter 2013crwdne2935289:0
CPSU-REGAN-W13S19G44
crwdns2931471:04crwdne2931471:0
crwdns2935297:026crwdne2935297:0
crwdns2944067:06crwdne2944067:0
My z button presses down and makes the click, but it does not actually send any input to the controller. How do you fix this?
So how do you put it back in like the replacement because I have a controller I'm working with a junker my Friend gave me and I'm trying to fix it the z button doesn't work here is a pic
My bad no pic it's a pelican wireless controller
How do you change the spring? I have replacement z buttons just no spring for them…
Does that silver bar on the bottom of the Z button supposed to be there? My Z button does not have that, is it important for the button to have that?
