crwdns2915892:0crwdne2915892:0
After removing the circuit board, the bottom LCD screen can easily be removed from the Nintendo DS.
crwdns2942213:0crwdne2942213:0
-
-
Remove the cartridge from the console.
-
Use a Phillips #00 Screwdriver to remove the screw securing the battery door to the rear case.
-
Remove the battery door.
-
-
-
Use a plastic opening tool or spudger to pry out the battery from the bottom. If a plastic opening tool or spudger isn't available, your fingernails may work.
-
-
-
Remove the battery from the Nintendo DS.
-
-
-
Remove the seven 6.4mm Y00 screws located on the back.
-
-
-
-
With your hands, pry the back panel off the main case.
-
Separate the back from the front, and set it aside.
-
-
-
Using a Phillips #00 screwdriver, remove the four screws on the circuit board.
-
-
-
Unlock the two large ribbon cables by moving the black clip up.
-
Carefully pull the ribbon cables down and out with your fingers.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Locate the two small ribbon cables, beneath the rightmost large ribbon cable.
-
Slide the locks for the small ribbon cables down to the side, and remove the cables.
-
-
-
Locate the Wifi antenna pigtail connector.
-
Remove the antenna by grasping it at the head with tweezers. Using a slight rocking motion, pull up to dislodge the connector.
-
-
-
Feed the ribbon cables through the opening on the board.
-
Pull up and remove the circuit board, and set it aside.
-
-
-
Peel off the black cushion foam on the bottom touch screen to expose the ribbon cable.
-
Gently lift the screen out of the base.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:022crwdne2935229:0
crwdns2947412:02crwdne2947412:0
I like it but add a step 12 maybe, to see how to put in a new screen.
Why was this unfinished guide published?
Or was it just mistitled?
"How to 'almost' remove the lower screen"