Nintendo 3DS Back Cover Replacement

crwdns2931653:01crwdne2931653:0 Back Cover

• Unscrew the four Phillips #00 screws along the top of the back cover.
• The screws are held in place by locking washers, and will not come out of the back cover.
• The comments section is full of unlucky souls who will tell you that the screws here through step 4 will strip incredibly easily. Press down fairly hard, and go slow.
crwdns2913378:0crwdne2913378:0
crwdns2935263:025crwdne2935263:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:02crwdne2931653:0



• Hold the device in one hand and turn it over.
• Grab the top edge of the back cover with your opposite hand so that the cover does not fall back into place.
• Flip the 3DS over again so that the back cover is facing up.
• Pull the back cover up and away from the rest of the device to remove it.
crwdns2913378:0crwdne2913378:0
crwdns2935261:0crwdne2935261:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

crwdns2935293:0crwdnd2935293:06crwdnd2935293:0crwdne2935293:0

David Hodson

crwdns2935283:004/13/10crwdne2935283:0

150,455 crwdns2915208:0crwdne2915208:0

crwdns2935297:0127crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 53

• 
• 
• 

crwdns2935301:050crwdne2935301:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0