crwdns2894164:0crwdne2894164:0

crwdns2890822:0crwdne2890822:0

crwdns2890844:0crwdne2890844:0

crwdns2861143:0crwdne2861143:0

crwdns2892376:0crwdne2892376:0

If you notice the LED lights on your device are continuously blinking or not working at all, this step-by-step guide will show you how to replace them individually, or all together. For soldering help, follow the How to Solder and Desolder Connections guide.

crwdns2860947:0crwdne2860947:0

crwdns2890040:0crwdne2890040:0

  1. On the circuit board, locate the LED light you wish to replace. On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc.
    • On the circuit board, locate the LED light you wish to replace.

    • On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc.

  2. Desolder the two LED leads to the specific bulb.
    • Desolder the two LED leads to the specific bulb.

    • Remove the LED from the circuit board.

    • Properly install the new LED and solder to the board.

crwdns2892372:0crwdne2892372:0

To reassemble your device, follow these instructions in reverse order.

Tommee Walker

crwdns2886885:022/08/2017crwdne2886885:0

691 crwdns2894548:0crwdne2894548:0

crwdns2886889:06crwdne2886889:0

crwdns2892814:0crwdne2892814:0

Arkansas State University, Team S1-G4, Chamberlain Fall 2017 crwdns2886886:0Arkansas State University, Team S1-G4, Chamberlain Fall 2017crwdne2886886:0

ARSU-CHAMBERLAIN-F17S1G4

crwdns2858115:02crwdne2858115:0

crwdns2886889:06crwdne2886889:0

crwdns2892924:00crwdne2892924:0

crwdns2892926:0crwdne2892926:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 3

crwdns2894768:030crwdne2894768:0 6

crwdns2894770:0crwdne2894770:0 219