crwdns2915892:0crwdne2915892:0
If you notice the LED lights on your device are continuously blinking or not working at all, this step-by-step guide will show you how to replace them individually, or all together. For soldering help, follow the How to Solder and Desolder Connections guide.
crwdns2942213:0crwdne2942213:0
- 
   
   - 
                     
            On the circuit board, locate the LED light you wish to replace. 
- 
                     
            On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc. 
 
- 
                     
            
- 
                     
                                                
- 
   
   - 
                     
            Desolder the two LED leads to the specific bulb. 
- 
                     
            Remove the LED from the circuit board. 
- 
                     
            Properly install the new LED and solder to the board. 
 
- 
                     
            
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
