crwdns2915892:0crwdne2915892:0
This guide shows how to remove a broken internal component for navigation buttons.
crwdns2942213:0crwdne2942213:0
-
-
Place the camera facing upwards.
-
Press down on the battery cover and slide towards the front face of the camera.
-
-
-
Rotate the orange battery clip in the camera to release the battery.
-
-
-
Locate the eight outer PH 2mm screws on the device.
-
Using the PH00 screwdriver remove all of the screws from the camera.
-
-
-
-
Using a plastic opening tool, gently pry off the front and rear plates.
-
Be patient with this step, do not force the clips holding the plates together.
-
-
-
Using a Phillips #00 screwdriver, remove the PH 2 mm screw located to the right of the screen, above the OK dial.
-
-
-
Disconnect the connectors using a plastic spudger.
-
-
-
You may now remove the internal panel of the buttons.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0