crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2861143:0crwdne2861143:0

Nikon Coolpix S210 Back Case Replacement

crwdns2915892:0crwdne2915892:0

This is the first part to taking apart your Nikon Coolpix S210.

crwdns2942213:0crwdne2942213:0

  1. Nikon Coolpix S210 Back Case Replacement, Battery: crwdns2935265:01crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Place thumb on the battery cover panel on the bottom of the device.

    • Slide the panel to the right away from the camera.

    crwdns2913378:0crwdne2913378:0

  2. Nikon Coolpix S210 Back Case Replacement: crwdns2935265:02crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Nikon Coolpix S210 Back Case Replacement: crwdns2935265:02crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Slide the orange latch outward towards the corner of the camera.

    • The battery should pop out.

    • Remove the battery and reattach the cover.

    crwdns2913378:0crwdne2913378:0

  4. Nikon Coolpix S210 Back Case Replacement, Back Case: crwdns2935265:03crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • After removing the battery, unscrew the four 3.10mm screws on the side opposite the buttons.

    crwdns2913378:0crwdne2913378:0

  5. Nikon Coolpix S210 Back Case Replacement: crwdns2935265:04crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Unscrew the three 4.05mm screws on the bottom of the camera below the lens.

    crwdns2913378:0crwdne2913378:0

  6. Nikon Coolpix S210 Back Case Replacement: crwdns2935265:05crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Unscrew the two 4.05mm screws on the side next to the buttons.

    crwdns2913378:0crwdne2913378:0

  7. Nikon Coolpix S210 Back Case Replacement: crwdns2935265:06crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Nikon Coolpix S210 Back Case Replacement: crwdns2935265:06crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Gently wedge the flat end of the spudger between the back case and the wrist-strap mount.

    • The wrist-strap mount is the thin metal piece on the side of the camera. Your camera may have the wrist-strap attached, but you will not need to remove it to continue.

    • Carefully pry the back case away from the camera and then gently lift it off.

    crwdns2913378:0crwdne2913378:0
crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order, paying careful attention to the locations of the different sizes of screws.

crwdns2935227:0crwdne2935227:0

crwdns2862417:0crwdne2862417:0

crwdns2935293:0crwdnd2935293:06crwdnd2935293:0crwdne2935293:0

Paul Doyle

crwdns2935283:001/20/11crwdne2935283:0

480 crwdns2915208:0crwdne2915208:0

crwdns2935297:03crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 11

crwdns2935301:08crwdne2935301:0

crwdns2915084:0crwdne2915084:0

Cal Poly, Team 5-17, Amido Winter 2011 crwdns2935289:0Cal Poly, Team 5-17, Amido Winter 2011crwdne2935289:0

CPSU-AMIDO-W11S5G17

crwdns2931471:06crwdne2931471:0

crwdns2935297:012crwdne2935297:0

crwdns2917034:0crwdne2917034:0

What about the front case so I can replace the flash board on top?

danwat1234 - crwdns2934203:0crwdne2934203:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 0

crwdns2936753:07crwdne2936753:0 1

crwdns2936753:030crwdne2936753:0 16

crwdns2942667:0crwdne2942667:0 2,266