crwdns2915892:0crwdne2915892:0
To reach internal components of the Nikon Coolpix L830 such as the motherboard and shutter button, first removing the back outer surface component is necessary. Following the steps of this prerequisite-only guide will allow you to remove the back casing and access internal components.
crwdns2942213:0crwdne2942213:0
-
-
Use a Phillips #000 screwdriver to unscrew the two 3.0mm Phillips screws located on the side of the camera with the HDMI port.
-
-
-
Unscrew the five 3.0mm Phillips #000 screws that are located on the bottom side of the camera.
-
-
-
Unscrew the 4.0mm Phillips #000 screw located underneath the grey flap on the side of the camera with the "DC IN 5.0 V" marker.
-
Unscrew the exposed 3.0mm Phillips #000 screw on the same side.
-
-
-
-
Press the flash button to open the flash component.
-
Remove the 3.0mm Phillips #000 screw located directly in-between the two arms.
-
-
-
Open the LCD monitor to reveal two 2.0mm Phillips screws.
-
Remove the 2.0mm Phillips #000 screws.
-
-
-
Insert a plastic opening tool between the back and front surface components of the camera.
-
Wiggle the plastic opening tool backwards and forwards along the top edge until the back surface comes off.
-
-
-
Gently pull the LCD ribbon connector up to allow the back casing to be completely removed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.