crwdns2915892:0crwdne2915892:0
This repair guide follows the back cover guide and requires the use of the spudger tool and Phillips screwdriver.
crwdns2942213:0crwdne2942213:0
-
-
Remove the batteries from the battery compartment by sliding the white battery compartment switch up and then move the panel toward the right.
-
-
-
Using the Phillips #000 screwdriver, unscrew the two 2mm screws next to the battery compartment on the right side of the camera.
-
-
-
Unscrew the two 2mm screws on the opposite side.
-
-
-
Flip over the rubber AV cover at the bottom of the camera. Unscrew the last two 2mm screws on the bottom of the camera.
-
-
-
-
Using your hands, open the camera slightly by using the indentation above the camera compartment.
-
-
-
Wedge the flat end of the spudger in between the front and back cover. Carefully push the spudger downward, which will lift the back cover off the camera.
-
-
-
Gently pull the cover off the camera.
-
-
-
Carefully flip over the LCD screen onto its front. Pull the top of the LCD screen toward you keeping the bottom of it inside the camera.
-
-
-
Gently hold the LCD screen down, so the ribbon lays flat against the back of the camera.
-
-
-
Gently wedge the spudger underneath the white latch and lift the latch open.
-
-
-
Use the flat side of the spudger to flip the white switch on the motherboard. You should hear a light click.
-
-
-
Gently pull the ribbon out of the switch.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
San Diego State, Team 1-3, Sheppard Winter 2015 crwdns2935289:0San Diego State, Team 1-3, Sheppard Winter 2015crwdne2935289:0
SDSU-SHEPPARD-W15S1G3
crwdns2931471:02crwdne2931471:0
crwdns2935297:06crwdne2935297:0
