crwdns2915892:0crwdne2915892:0
Removing the front face is necessary if the colored plate is damaged. This process is also a prerequisite for various other repairs.
crwdns2942213:0crwdne2942213:0
-
-
Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left.
-
-
-
You should feel the door begin to loosen. Carefully pull the hatch open.
-
-
-
-
Push the yellow battery/charger compartment tab up using your thumb nail.
-
-
-
After pressing the yellow tab, the battery should loosen.
-
Slowly pull the battery completely out.
-
-
-
Using the T4 Torx Screwdriver, remove the 2, 4mm screws holding the N-Mark plate in place.
-
Carefully pull the plate off of the face.
-
-
-
Using the metal spudger tool, pry the colored face from the camera body.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2917034:0crwdne2917034:0
Hello, has this front panel influence on cameras sealing function? Or is it only as shield against mechanical demage?