crwdns2915892:0crwdne2915892:0
Removing the front face is necessary if the colored plate is damaged. This process is also a prerequisite for various other repairs.
crwdns2942213:0crwdne2942213:0
- 
   
   - 
                     
            Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left. 
 
- 
                     
            
- 
   
   - 
                     
            You should feel the door begin to loosen. Carefully pull the hatch open. 
 
- 
                     
            
- 
                     
                                                
- 
   
   - 
                     
            Push the yellow battery/charger compartment tab up using your thumb nail. 
 
- 
                     
            
- 
   
   - 
                     
            After pressing the yellow tab, the battery should loosen. 
- 
                     
            Slowly pull the battery completely out. 
 
- 
                     
            
- 
   
   - 
                     
            Using the T4 Torx Screwdriver, remove the 2, 4mm screws holding the N-Mark plate in place. 
- 
                     
            Carefully pull the plate off of the face. 
 
- 
                     
            
- 
   
   - 
                     
            Using the metal spudger tool, pry the colored face from the camera body. 
 
- 
                     
            
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Hello, has this front panel influence on cameras sealing function? Or is it only as shield against mechanical demage?
