crwdns2915892:0crwdne2915892:0
This guide is to be used to install the battery in the case that the battery dies or no longer functions properly. A Phillips screwdriver will be needed to complete this installation.
crwdns2942213:0crwdne2942213:0
-
-
Using the thumb, firmly push the SD/Battery cover in the middle and then in the direction of the arrow on the SD/Battery cover.
-
This will cause the SD/Battery cover to pop open.
-
-
-
Press orange clip to eject battery (battery not shown).
-
-
-
-
While cupping hand under the bottom of the SD/Battery slot, turn the camera upright.
-
This will cause the battery to fall into the hand (battery not shown).
-
-
-
Following the positive and negative placement signs, slide the new battery into the battery slot (battery not shown).
-
-
-
Slide the SD/Battery cover in the reverse direction of the arrow on the SD/Battery cover until it clicks into place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0