Nikon COOLPIX S610c LCD Replacement
crwdns2944107:0crwdnd2944107:0Kevin Backerscrwdnd2944107:0crwdnd2944107:0crwdnd2944107:03crwdnd2944107:0crwdne2944107:0
crwdns2944111:0August 4, 2020crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0If your screen has stopped working or needs to be replaced for some other reason, follow this guide to remove your current screen.
crwdns2942213:0crwdne2942213:0
-
-
On the bottom right of the camera, locate the battery flap switch.
-
-
-
Move this switch to the right so the battery flap can flip open.
-
-
-
Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.
-
-
-
Remove the three 3x3mm screws attached to the rear casing.
-
-
-
Remove the 5x3mm screw holding down the panel on the side closest to the lens.
-
-
-
Pry the panel off from the bottom using your fingernail.
-
-
-
Remove the 3x2mm screw underneath the panel near the top of the camera.
-
-
-
Remove the 4x3mm on the opposite side near the selector wheel.
-
Remove the 2x2mm and 3x2mm screws underneath the a/v flap.
-
-
-
Pry the back panel away from the body of the camera, using the space you just opened up.
-
A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.
-
-
-
Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.
-
-
-
Pry the display from the rear casing using a spudger.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 9-5, Regan Winter 2012 crwdns2935289:0Cal Poly, Team 9-5, Regan Winter 2012crwdne2935289:0
CPSU-REGAN-W12S9G5
crwdns2931471:05crwdne2931471:0
crwdns2935297:012crwdne2935297:0
