crwdns2894164:0crwdne2894164:0
  1. Remove Micro SD card and Battery
    • Remove Micro SD card and Battery

  2. Remove 2 screws Open plastic LCD connector cover Lift FPC connector latch
    • Remove 2 screws

    • Open plastic LCD connector cover

    • Lift FPC connector latch

    • Detach LCD FPC

  3. Remove 4 screws Remove LCD module Remove LCD module
    • Remove 4 screws

    • Remove LCD module

  4. WARNING!!! DO NOT TOUCH THESE Solder joints!!! High Voltage up to 300V..
    • WARNING!!! DO NOT TOUCH THESE Solder joints!!! High Voltage up to 300V..

    • Or discharge the flash condenser first, as per "Main PCB replace guide"

    • Remove 3 screws

  5. Left side, in connector bay, remove 2 screws. Bottom, reomve 2 screws Right side, remove 1 screw
    • Left side, in connector bay, remove 2 screws.

    • Bottom, reomve 2 screws

    • Right side, remove 1 screw

  6. Peel here and remove 1 screw within.
    • Peel here and remove 1 screw within.

  7. Pop open back case and remove it from body. Pop open back case and remove it from body.
    • Pop open back case and remove it from body.

  8. Disconnect speaker Disconnect keypad FPC Disconnect keypad FPC
    • Disconnect speaker

    • Disconnect keypad FPC

  9. Push latches from below
    • Push latches from below

    • pop up and remove keypad.

crwdns2892372:0crwdne2892372:0

To reassemble your device, follow these instructions in reverse order.

Terrance

crwdns2886885:017/11/2009crwdne2886885:0

5,164 crwdns2894548:0crwdne2894548:0

crwdns2886889:010crwdne2886889:0

crwdns2892924:00crwdne2892924:0

crwdns2892926:0crwdne2892926:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 0

crwdns2894768:030crwdne2894768:0 0

crwdns2894770:0crwdne2894770:0 24