crwdns2942213:0crwdne2942213:0
-
-
Using two fingers, push up on the rear cover.
-
-
-
Using the plastic opening tools, pry the left bottom corner of the battery up.
-
-
-
-
Remove the two Torx T5 screws.
-
Remove the one Philips #00 screw.
-
-
-
Using the plastic opening tool, pry up the battery housing upwards.
-
Push pry tool down, undoing the plastic tab.
-
-
-
Pry the upper left tab open on the battery housing.
-
-
-
Pry the top tab of the battery housing.
-
-
-
Pry the right side tab of the battery housing.
-
-
-
Pull up on the battery housing.
-
Slide the battery housing out to remove it.
-
-
-
Using the spudger, pry upwards on the second microphone connector.
-
-
-
Pull up on the ribbon cable, the tape will detach from the main board ribbon.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.