crwdns2915892:0crwdne2915892:0
I bought a kit to fix this component. The kit contained the headphone jack itself, a Phillips #00 Screwdriver and an Opening Tool.
I made do with just the above tools, but my instructions use the ideal tools should you have them.
I also replaced the rear camera at the same time, by following the excellent guide for that component.
crwdns2942213:0crwdne2942213:0
-
-
Insert a SIM card eject tool or a paper clip into the hole next to the SIM card slot, which is located just under the power button. Do not force the paper clip if it is too thick; instead use the head of a sewing needle.
-
Push the tool into the hole until you see the card pop out.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Gently remove the SIM card with your fingers, or a pair of tweezers if the SIM holder does not fully eject.
-
-
-
Use a plastic opening tool to free the clips on the top and each side of the back cover.
-
-
-
Remove the six 4.0 mm Phillips #00 screws that secure the midframe to the phone.
-
To replace the LCD screen and digitizer, remove the additional four 4.0mm daughterboard cover screws with the same screwdriver. You may have to pierce through clear adhesive material to remove them.
-
-
-
crwdns2935267:0crwdne2935267:0Spudger$2.99
-
Use the flat end of a nylon spudger to disconnect the battery connector.
-
-
-
Use the flat end of a spudger to disconnect the daughterboard ribbon cable and pull it away from the battery.
-
-
-
Use a plastic opening tool to pry the battery out of its housing.
-
If replacing the battery, bag the old battery up and recycle responsibly at a suitable location.
-
-
-
Use the flat end of a spudger to disconnect the left antenna cable.
-
-
-
Use the flat end of a spudger to disconnect the right antenna cable.
-
-
-
Use the flat end of a spudger to disconnect the ribbon cable that connects rear-facing camera to the motherboard.
-
-
-
Use the flat end of a spudger to disconnect the front camera ribbon cable.
-
-
-
Gently lift the motherboard up and out of the device.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use a spudger or tweezers to pull the headphone jack upward and out of the phone.
-
Place the new headphone jack by orienting it like the old one and pressing it gently down into the phone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0