crwdns2942213:0crwdne2942213:0
-
-
Using a plastic opening tool, remove the thin plastic cover from back of the tablet by prying up from its small tab.
-
-
-
Remove the five 2mm screws on the back of the device using a PH00 screwdriver.
-
-
-
Pry the device apart by inserting a plastic opening tool in the seam between the plastic backing and display assembly. Use the tool to unclip the plastic tabs in between the backing and the display.
-
Pull the the plastic backing off the display assembly using your hands.
-
-
-
Detach the three connector ribbons passing over the battery using the plastic opening tool.
-
-
-
Remove the twelve 2mm screws around the perimeter of the battery with a PH00 screwdriver.
-
-
-
-
Disconnect the battery by lifting it upward and pulling it away from the connector.
-
-
-
Remove one screw on the logic board with a PH00 screwdriver.
-
-
-
Disconnect right speaker connector ribbon from logic board.
-
Lift the speaker out by pulling up on its corner.
-
-
-
Disconnect connectors around the perimeter of the motherboard.
-
-
-
Remove motherboard by gently pulling upward under its corner.
-
-
-
Remove the three 2mm screws along the right side of the device using a PH00 screwdriver.
-
-
-
Unseat the small vibrator motor by gently applying upward pressure with a spudger.
-
-
-
Lift the assembly by gently applying upward pressure with the spudger on the assembly.
-
-
-
Gently pull battery-audio jack-USB assembly upward, detaching it from its adhesive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 34-18, Maness Spring 2016 crwdns2935289:0Cal Poly, Team 34-18, Maness Spring 2016crwdne2935289:0
CPSU-MANESS-S16S34G18
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
