crwdns2915892:0crwdne2915892:0
This guide will show you how to replace the springs in a Nerf N-Strike Elite Rough Cut 2x4 gun. Nerf guns use springs to power their guns. However, over time, these springs lose power and thus the gun cannot shoot as far or as powerfully. When this happens, the gun can simply not be effective for Nerf fights. However instead of buying a new gun and throwing away the old one you can simply add new springs and get the same if not better performance.
crwdns2942213:0crwdne2942213:0
-
-
Remove three screws with a Phillips #1 screwdriver.
-
Remove the pump grip.
-
-
-
Remove thirteen highlighted screws using a Phillips #1 screwdriver.
-
-
-
-
Remove the backside by sliding the plastic spudger across the seam.
-
-
-
Separate the trigger mechanism from the barrel.
-
-
-
Remove the plunger springs from the mechanism by pulling one of the springs back then bending it off the connection.
-
-
-
Now pull the springs out and add new ones.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team 1-4, Rauch Fall 2021 crwdns2935289:0Embry-Riddle Aeronautical University, Team 1-4, Rauch Fall 2021crwdne2935289:0
ERAU-RAUCH-F21S1G4
crwdns2931471:03crwdne2931471:0
crwdns2935303:01crwdne2935303:0
