crwdns2915892:0crwdne2915892:0
In this guide you will be able to replace the battery component of the Neato Botvac Connected. Make sure the battery has fully drained before beginning. This repair may be needed if the Neato Botvac is not charging while being plugged into the charging dock. This also may be needed if the battery is not holding charge as long as it should. Removing the battery is a prerequisite to the following guides for safety.
crwdns2942213:0crwdne2942213:0
-
-
Place the top of the Neato Botvac Connected against a flat surface.
-
-
-
Remove the two 5.5 mm screws with a Phillips #2 screwdriver.
-
-
-
-
Using the spudger, remove the panel covering the battery.
-
-
-
Gently remove the connecting wires attached to the battery.
-
-
-
Using the spudger, gently remove the battery from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.